Connecting The Power Cord - Salora 32LED9112CSW Mode D'emploi

To change volume: Increase the volume by pushing
the button up. Decrease the volume by pushing the
button down.
To change channel: Press the middle of the button,
the information banner will appear on the screen.
Scroll through the stored channels by pushing the
button up or down.
To change source: Press the middle of the button
twice (for the second time in total), the source list will
appear on the screen. Scroll through the available
sources by pushing the button up or down.
To turn the TV off: Press the middle of the button
down and hold it down for a few seconds, the TV will
turn into standby mode.
Notes:
• If you turn the TV off, this circle starts again
beginning with the volume setting.
• Main menu OSD cannot be displayed via control
buttons.
Operation with the Remote Control
Press the Menu button on your remote control to
display the main menu screen. Use the Left or Right
button to select a menu tab and press the OK to enter.
Use Left / Right / Up / Down buttons to select or set
an item. Press Return/Back or Menu button to quit
a menu screen.
Input Selection
Once you have connected external systems to your
TV, you can switch to different input sources. Press the
Source button on your remote control consecutively
to select the different inputs.
Changing Channels and Volume
You can change the channel and adjust the volume
by using the Volume +/- and Programme +/- buttons
on the remote.
Putting batteries in the remote control
Lift the cover at the back of the remote control.
Insert two AAAsize batteries. Make sure that the +
and – ends of the batteries match the in the battery
compartment (respect the right polarity). Put the cover
back in place.

Connecting the power cord

IMPORTANT: This television is designed to operate
solely with a 220-240V ~ 50 Hz. power supply. After
taking the television out of its package, wait a bit for the
TV to reach ambient temperature before connecting it
to the electricity plug. Connect the power cord to the
main plug.
Connecting the antenna/Cable
Connect the aerial or cable TV plug to AERIAL INPUT
(ANT-TV) socket located on the rear bottom side of
the TV.
SPDIF
Notification
Manufactured under licence from Dolby Laboratories
MANUFACTURED UNDER LICENCE
"Dolby" and the double D symbol are trademarks of
Dolby Laboratories.
HDMI, the HDMI logo and the high definition
multimedia interface are marks or registered
trademarks of HDMI Licensing LLC.
"DLNA , the DLNA Logo and DLNA CERTIFIED
®
trademarks, service marks, or certification marks of
the Digital Living Network Alliance."
English - 51 -
Aerial or Cable
VGA
are
®