Control Wiring; Junction Box - Cooper Metalux XHB Manuel D'installation

NEVER connect the bare or green insulation ground wire to the black (HOT) current-carrying or white (NEUTRAL)
supply wire, as this could energize the metal housing and create the risk of electrical shock. FAILURE TO FOLLOW
THIS WARNING MAY LEAD TO DEATH, SEVERE INJURY, OR PROPERTY DAMAGE.
Do not damage or cut the wire insulation (covering) during installation. Do not permit wires to contact any surface
having a sharp edge, as this may damage the wire insulation and create the risk of electrical shock. FAILURE TO
FOLLOW THIS WARNING MAY LEAD TO DEATH, SEVERE INJURY, OR PROPERTY DAMAGE.

Control Wiring

Always turn power to luminaire OFF before performing any work on control wiring. Turn transmitters off before
working on main control lines. Performing any work on control connections while fixtures are receiving the signal
may result in transient or fluttering control signals which can cause damage to the luminaire. FAILURE TO FOLLOW
THIS WARNING MAY LEAD TO LUMINAIRE INTERNAL DAMAGE AND FAILURE.
Use caution when connecting any 24AWG wires as they are more prone to breaking. 24 AWG may be used in
terminal blocks. If wire will be connected with wire nut, wago connector, or other mechanical splices, use 22AWG
wire.
1. If wired controls are required, route the incoming control line into the left side of the luminaire junction box by removing
the plug and routing through ½" cord grip. Secure the cord in the grip by hand tightening the sealing nut as far as
possible. Hold the body hex stationary with a wrench, using a second wrench; tighten the sealing nut until the cable is
securely held in place.
2. Connect the incoming control wires to the applicable luminaire control wires. See Table 5 below for identification of
wires on luminaire.

Junction box

1. Ensure all power and control wires are securely terminated and there are no exposed conductors. Carefully push power
and control wires down into the junction box to ensure no wires get pinched by the cover.
2. Replace the junction box and Qty. (2) junction box screws and lock washers. Torque junction box screws to 40 in-lbs.
XHB SAFETY CABLE INSTALLATION
The optional XHB safety cable will provide additional safety protection from an improperly installed luminaire or a weak
mounting structure. It shall be utilized only as a secondary safety and not the primary means of mounting.
Cable Options:
Gripple Hanger with 1/8" diameter cable and loop termination
● ●
Part Number: Gripple Loop Hanger No. 3
● ●
Installation Instructions - Extreme High Bay Installation Manual
WARNING
WARNING
WARNING
WARNING
Luminaire control wire color
Purple
Grey
Yellow
Table 5. Control Wiring Connections
COOPER LIGHTING SOLUTIONS
Designation
Data +
Data -
Shield
IB507004EN Installation instructions
7