Wiring Diagrams - Cooper PORTFOLIO LDRT4B Instructions D'installation

Installation Instructions – LDRT4B/LDRT6B/LDRT67B Commercial Recessed LED Retrofit
Driver Replacement
CAUTION
To avoid possible electrical shock, be sure that the power is
turned off before installing or servicing this fixture.
• The driver should be replaced by a qualified electrician.
• The driver may be replaced either from below or above
the ceiling.
1. Remove trim assembly from the housing (Figure 35).
2. Remove the driver and junction box cover assembly.
(Figure 40).
3. Disconnect the wiring to the driver by undoing the
lever nut connectors then cut the red and blue wires.
4. Discard the old driver and junction box cover assembly.
5. Connect the new driver leads with the lever nut
connectors.
6. Reattach the new driver and junction box cover
assembly.
Figure 39
Driver
Figure 40
8
Installation Instructions – LDRT4B/LDRT6B/LDRT67B Commercial Recessed LED Retrofit
IB520015EN
Lever Closed
Close Lever To
Secure Wire
Figure 41

Wiring Diagrams

1. For D010
BLACK (LINE) BLACK (LINE)
0-10V DIMMING
WHITE WHITE
(NEUTRAL) (NEUTRAL)
GROUND
2. For D010TR
BLACK (LINE) BLACK (LINE)
LINE VOLTAGE
DIMMING OR
0-10V DIMMING
WHITE (NEUTRAL) WHITE (NEUTRAL)
AT 120-277VAC
DUAL DIMMING
GROUND
3. For D010TE
BLACK (LINE) BLACK (LINE)
TRAILING EDGE
WHITE WHITE
OR 0-10V DIMMING
(NEUTRAL) (NEUTRAL)
GROUND
www.cooperlighting.com
Lever Open
Open Lever To
Release Or Insert
Wire
RED
BLUE
DRIVER
PURPLE
GRAY
RED
BLUE
PURPLE
DRIVER
GRAY
MOUDLE WIRING
RED
BLUE
DRIVER.
PURPLE
GRAY
MODULE WIRING
RED
LED
BLACK
MOUDLE WIRING
DIAGRAM
0-10V
DIMMING
OPTION
(FIELD
INSTALLATION)
RED
LED
BLACK
DIAGRAM
0-10V
DIMMING
OPTION
(FIELD
INSTALLATION)
RED
LED
BLACK
DIAGRAM
0-10V
DIMMING
OPTION
(FIELD
INSTALLATION)