Care And Maintenance - Cooper Metalux XHB Manuel D'installation

Installation Instructions - Extreme High Bay Installation Manual
Installation:
1. The cable must be looped around the thick heat sink ring and back onto itself as shown in the figures below.
2. Affix to secondary structure that is sufficient enough to support the luminaire shall it be necessary.
Figure 6.

CARE AND MAINTENANCE

All Extreme high bay fixtures have a powder-coated finish. The finish on exterior luminaires may weather over time,
depending on the environmental conditions at the installation site. Proper care of the luminaires will maintain their
performance and appearance.
The buildup of dirt and debris on the heat sink can hinder the performance of the LED luminaire. Excess build-up within
the heat sink fins can cause the lumen output to automatically decrease in order to protect the luminaire from overheating.
Follow a regular maintenance schedule to retain optimal light output and thermal performance. Remove any dirt, leaves and
other foreign debris from the luminaire housing. Wipe the optical lenses with a clean, dry, cotton cloth to remove dust and
other contaminants. A non-abrasive polycarbonate cleanser may be used periodically.
Do NOT use any abrasives such as car wax, brass cleaners or other polishes or chemicals. These may scratch,
remove, or damage the protective coating, allowing moisture and pollutants to come into contact with the
aluminum, possibly discoloring or pitting the finish.
8
COOPER LIGHTING SOLUTIONS
WARNING
IB507004EN Installation instructions
Inner Heat Sink Ring
Safety Cable