GE Monogram ZBD6800 Manuel Du Propriétaire page 18

Masquer les pouces Voir aussi pour Monogram ZBD6800:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Questions?
PROBLEM
Use this
Yellow or brown film
on inside surfaces
problem
solver
White film on inside
surfaces
Dishes don't dry
Dishwasher won't run
Steam
18
Before You Call For Service
POSSIBLE CAUSE
Tea or coffee stains
An overall yellow or brown
film can be caused by iron
deposits in water
Hard water minerals
Low inlet water
temperature
Rinse agent dispenser is
empty
Door not latched
Wall switch
(some installations) is in
the "off" position
Fuse is blown, or the
circuit breaker tripped
Dishwasher control
is inoperative
This is normal
Dishwasher
WHAT TO DO
• Remove the stain by hand, using a solution
of 1/2 cup bleach and 3 cups warm water.
CAUTION:
Before cleaning
interior, wait at least 20 minutes after a
cycle for the heating element to cool
down. Failure to do so can result in burns.
• A special filter in the water supply line is
the only way to correct this problem.
Contact your GE dealer or a water softener
company
• GE recommends Jet-Dry
Crystal Clear
®
to help prevent hard water
mineral deposits from forming.
• Run dishwasher with citric acid to remove
mineral deposits. Citric acid (Part number:
WD35X151) can be ordered through GE
Parts. See the Consumer Services page
for ordering information.
CAUTION:
Before cleaning
interior, wait at least 20 minutes after a cycle
for the heating element to cool down. Failure
to do so can result in burns.
• Select HEATED DRY.
• Make sure inlet water temperature is at least
120°F (49°C) (see Using the Dishwasher section).
• Select ADDED HEAT.
• Use a longer cycle, such as Antibacterial.
• Check and refill the rinse agent dispenser.
• Make sure door is fully closed and latched.
• Check for a wall switch that the dishwasher
might be connected to. A wall switch is
required by electrical codes in some
localities. Turn the switch "on" if it is "off."
• Replace fuse or reset circuit breaker. Remove
any other appliances from the circuit.
• Turn off power at the circuit breaker
for 30 seconds, then reset power.
• Warm moisture comes through the vent
on the bottom of the door during drying
and when water is being pumped out.
®
or Cascade

Publicité

Chapitres

Table des Matières
loading

Table des Matières