Press The Start Button; Drying Programme Finished - grandimpianti GD6 Manuel D'installation Et D'utilisation

Tumble drying

Press the Start button

5
Remaining drying time
An estimate of the remaining drying time
will be shown on the display a few minutes after
the drying programme starts. For example, "1:35"
means that it will take approximately 1 hour and
35 minutes for the load to dry.
The actual remaining time may be longer than the
estimated time shown on the display. The
remaining time is then shown as "0:15" until the
load is sufficiently dry.
You can stop the tumble dryer by pressing the
Stop button or by opening the door. In both cases
the programme is stopped and starts from the
beginning if restarted.
NOTE!
The programme will not be affected if you
change the programme selector after the
programme has started.

Drying programme finished

6
The text "Done" appears on the display
when the programme is finished.
Backlighting
Two minutes after the drying programme finishes
the backlighting on the display and option buttons
enters energy saving mode.
NOTE!
• Clean the lint filter after each load.
WARNING!
If the lint filter becomes clogged, the machine's
automatic overheating cut-out may be triggered.
Clean the filter, wait until the machine has
cooled then try starting it. If it still does not start:
Call the service division.
Once drying has finished
Turn off the main power switch. Remove the
clothes and close the door to prevent small
children from climbing into the machine.
11