Press The Start Button; Drying Programme Finished; Once Drying Has Finished - grandimpianti GD6 Manuel D'installation Et D'utilisation

Tumble drying

Press the Start button

5
Remaining drying time
An estimate of the remaining drying time
will be shown on the display a few minutes after
the drying programme starts. For example, "1:35"
means that it will take approximately 1 hour and
35 minutes for the load to dry.
The actual remaining time may be longer than the
estimated time shown on the display. The
remaining time is then shown as "0:15" until the
load is sufficiently dry.
Stopping or changing a programme
Press and hold button the Stop button for three
seconds.
Note!
The programme will not be affected if you
change the programme selector after the
programme has started.
Loading or removing washing
You can stop the tumble dryer after starting a
programme by opening the door. Load more
washing or take out the items you want, close the
door and press the Start button. A new estimate
of the remaining programme time will be displayed
after a few minutes.
12

Drying programme finished

6
The text "End" appears on the display when
the programme is finished.
Backlighting
Two minutes after the drying programme finishes
the backlighting on the display and option buttons
enters energy saving mode.
Important!
• Clean the lint filter after each load.
Caution!
If the lint filter becomes clogged, the machine's
automatic overheating cut-out may be
triggered. In order to be able to restart the
machine, you must clean the filter and allow
the machine to cool down for around 30
minutes.

Once drying has finished

7
Turn off the main power switch. Remove
the clothes and close the door to prevent
small children from climbing into the machine.