Control Panel; Use Of The Programming Wheel; Quick Configuration - V2 FORTECO Serie Mode D'emploi

CONTROL PANEL

When power is on, the control unit checks that display correctly
operates by switching on all segments for 1.5 sec. 8.8.8.8.
Firmware version, e.g. Pr I.4, will be viewed in the following 1.5
sec. Panel will be viewed upon completion of this test.
The control panel represents the physical status of the
terminal board contacts and of the program mode keys: if the
upper vertical segment is on, the contact is closed; if the lower
vertical segment is on, the contact is open (the above picture
shows an instance where the inputs LIMIT SWITCH, FOTO 1,
FOTO 2, COSTA 1, COSTA 2 and STOP have all been correctly
connected).
The dots among the ciphers of the display show the status of
the programming wheel: when pushing the wheel downwards
the left dot is on (DOWN), when pushing the wheel upwards the
right dot is on (UP), when the wheel is pressed the central dot
is on (MENU).
The arrows on the left of the display show the state of the start
inputs. The arrows light when the related input is closed.
The arrows on the display right side show the gate status:
• The highest arrow turns on when the gate is into its opening
phase. If it blinks, it means that the opening has been
caused by a safety device (border or obstacle detector).
• The central arrow shows that the gate is on pause. If it
blinks, it means that the time countdown for the automatic
closing has been activated.
• The lowest arrow blinks when the gate is into its closing
phase. If it blinks, it means that the closing has been
caused by a safety device (border or obstacle detector).
USE OF THE PROGRAMMING
WHEEL
A special configuration menu – accessible and explorable by
means of the small wheel on the right side of the display - allows
programming the functions and times of the control unit .
WARNING: Outside the configuration menu, pushing the
wheel upwards a START control is given, pushing it
downwards (DOWN) a PEDESTRIAN START control is given.
To start the programming mode while the display is showing
the control panel, keep the wheel pressed until the display
shows -PrG.
Keeping the wheel pressed, it is possible to scroll the 4 main
menus:
-PrG programming of the CONTROL UNIT
-Cnt counters
-APP Self-learning of TIMES AND FORCES
-dEF loading of default parameters
To enter one of the 4 main menus release the wheel when joined
the interested menu.
To move inside the 4 main menus push the wheel downwards or
upwards to scroll the different items; pressing the wheel, the
actual value of the selected entry is visualized and, if necessary,
can be changed.

QUICK CONFIGURATION

This paragraph concerns a quick procedure to set the control
unit and set it at work immediately.
We recommend following these instructions, in order to
check quickly the correct operation of control unit, motor
and accessories, and then changing the configuration in
case of any non-satisfactory parameter.
1. Call up the default configuration: see paragraph "LOADING
OF DEFAULT PARAMETERS"
2. Set items StoP, Fot1, Fot2, CoS1, CoS2 according to the
safety devices installed on the gate.
3. Start the self-learning cycle: see paragraph "SELF-LEARNING
OF WORKING TIMES "
4. check that the automation work properly and if necessary
modify the configuration of the desired parameters. For the
position of the item menus inside the main menu and for the
options related to each item menu, refer to the paragraph
"CONFIGURATION OF THE CONTROL UNIT".
38