Assembly; Fixed Position Coupling; Quick Couple; Operating Instructions - GOLDONI 32 Emploi Et Entretien

2. ASSEMBLY

2.1 FIXED POSITION COUPLING

To attach the brush clearer to tractors fitted with fixed position hitches, the brush
clearer is coupled to the rear studs of the motor cultivator.

2.2 QUICK COUPLE

Top attach the brush clearer to tractors with quick couples, you will need the
requisite flange (to be ordered separately).
This flange is fixed to the brush clearer casing using the necessary studs,
washers and nuts.
to couple the brush clearer to the machine: insert brush clearer sleeve A fig.2
until coupler B has clicked completely into place
Make sure that stop notch C is positioned as shown in fig. 2.
To separate the machine from the transmission, follow these steps:
− with the engine running
− PTO in neutral
− Engage 1st reverse gear
− If the machine has it, use the implement release lever on the handlebar. This
will release couple B fig. 3. If the machine does not have this release lever,
release the coupler by hand.
− Let the clutch out a little to move the machine back slightly.

3. OPERATING INSTRUCTIONS

Be very careful when dealing with the blade. Since it is centrifugal, the working
diameter increases as the engine's Rpm increase.

4. MODEL IDENTIFICATION DATA

Model and series are the machine's identification data. They are stamped on the
casing flange n.1 fig.1
Use only original parts.
21