Twist Ice - Matic; Ice Container - Beko RDNT340I20S Mode D'emploi

Twist Ice – matic
(This feature is optional)
• Remove the water tank by rotating it
to the left.
• Open the water tank cover by turning
it and add water to the water tank
up to the lower part of the water tank
cover.
• Place the water tank on its place as
shown in the figure after adding water
and have it seated by rotating it on
the direction of the arrow. Water shall
be poured down to the icebank.
• When ice has formed, rotate icebank
knob in the direction of the arrow to
allow that the ice is dropped down to
the ice drawer.
• Take the ice cubes by pulling ice
drawer out.
• Pull the front face towards you in
order to wash the icebank, and put it
on the slides on the interior area and
push it to its place in order to replace
it.
• Pull the twist icematic unit towards
you in order to remove the unit, and
put it on the slides on the ceiling and
push it to its place in order to replace
it.

Ice container

• Remove the ice container from the
freezer compartment.
• Fill the ice container with water.
• Place the ice container in the freezer
compartment. About two hours later,
the ice is ready.
• Remove the ice container from the
freezer compartment and bend it over
the service plate. Ice cubes will easily
fall down to the service plate.
20
EN