Skil RAS800 Consignes De Fonctionnement/Sécurité page 22

the workpiece should be held against the
router table fence when routing.
ADJUSTING THE FENCE
FACEPLATES (Fig. 21)
The right and left fence faceplates are
attached to the front face of the router table
fence and can be adjusted inward or outward
from the router bit to allow proper clearance
for different-sized bits. To provide the best
support during routing operations, the fence
faceplates should be as close to the bit as
possible without being able to come in contact
with the bit (typically about 1/4" from the bit is
a suitable distance).
1. Loosen the clamping knob (18) and
carriage bolt (32) securing each fence
faceplate (16) and slide the faceplates
inward or outward from the router bit as
needed.
router table fence when routing. Such
precautionary safety measures increase
the accuracy in routing and improve the
control of the workpiece reducing the risk
of personal injury.
2. Once the fence faceplates (16) are in
the desired position, tighten the clamping
knobs (18) and carriage bolts (32)
SECURELY.
Router Table Operation
For accuracy in routing
and improved control,
Always hold the
workpiece against the
18
FIG. 21
Guard not shown for clarity
22
16
32
18 32