Skil RAS800 Consignes De Fonctionnement/Sécurité page 15

before installing router into the table,
making adjustments, changing
accessories, removing the router from
the table, performing maintenance,
or storing the tool. Such precautionary
safety measures reduce the risk of
unintentional tool operation.
INSERT RINGS (Fig. 15)
This router table (1) includes five insert rings
with the following hole sizes:
(11A) 1/2" diameter, for use with bits up to
3/8" diameter
(11B) 3/4" diameter, for use with bits larger
than 3/8" and up to 5/8" diameter
(11C) 1" diameter, for use with bits larger
than 5/8" and up to 7/8" diameter
(11D) 1¼" diameter, for use with bits larger
than 7/8" and up to 1
(11E) 1½" diameter, for use with bits larger
than 1 ⁄ " and up to 1
1
8
No insert ring is required for bits with
diameters between 1½" and 1
in diameter. Bits larger than 1
the clearance hole in the tabletop insert
rings. Bits larger than 1
plate or insert ring, throwing fragments.
These five insert rings are supplied individually
and can be found in the storage bag. The insert
ring should fit into the tabletop hole completely.
Use a fine file or emery board to remove excess
plastic or rough edges that may cause the insert
ring to protrude above the table surface.
Match the cutting diameter of the bit to the
inner diameter of the insert ring or insert
plate bit hole such that the difference is no
less than 1/16" on a side. Insert rings are
meant to reduce the gap between the cutting
diameter of the bit and table so that
workpieces maintain full support of the table
while routing.
Router Table Setup
Disconnect the router
from the power supply
⁄ " diameter
1
8
⁄ " diameter
3
8
⁄ ".
5
8
Do not use the router
table with bits over 1
⁄ " exceed
5
8
⁄ " can contact insert
5
8
Do not alter insert ring or
insert plate bit hole.
FIG. 15
1
TO INSTALL TABLETOP
INSERT RINGS (Fig. 15)
⁄ "
5
8
1. Select the insert ring (11A–11E) that best
accommodates the router bit to be used.
2. Press the insert ring (11A–11E) into
the large hole in the plastic insert plate (2).
3. Press down evenly over the tabs until
the insert ring locks into place.
4. To remove, pull up gently until the tabs
disengage. When not in use, store insert
rings (11A–11E) in the tool bag or a
convenient place.
tabletop insert ring from the tabletop
unless the router is off and unplugged.
Such precautionary safety measures reduce
the isk of unintentional tool operation.
15
2
Do not use, attempt to
change, or remove
11A
11B
11C
11D
11E