Skil RAS800 Consignes De Fonctionnement/Sécurité page 12

INSTALLING THE FENCE ASSEMBLY
(Fig. 7)
The fence comes assembled. Step 1 refers to
reassembly, if necessary; otherwise, go to Step 2
if already assembled.
1. From underneath, slide two 1/4-20 x 1¾"
carriage bolts (32) up through the holes in
the bottom of the fence assembly (C).
Loosely attach a clamping knob (18) onto
each bolt. (See Fig. 7.)
2. Insert the carriage bolt heads (32) through
the holes of the J-slots on the tabletop (1),
making sure the bolt heads are below the
inside surface of the tabletop and can slide
freely in the J-slot.
3. From the rear of the table assembly, slide the
fence assembly (C) right and into the J-slot
and make sure that it slides smoothly from
front to back.
4. Tighten the large clamping knobs (18) to
secure the fence assembly (C) to a desired
position.
MITER GAUGE ASSEMBLY (Fig. 8)
The miter gauge assembly (D) comes fully
assembled. If necessary, use the following
instructions to assemble it.
1. Screw the #10-16 x 1/2" self-tapping,
pan-head screw (26) through the round
hole in the miter bar (20) and into the
protractor head (21).
2. Tighten the screw so that the screw head
just touches the miter bar. The protractor
head should turn easily. If not, loosen the
screw slightly.
3. Insert the #10-24 x 3/4" carriage bolt (29)
through the square hole in the miter bar
(20) and slot in the miter gauge and secure
with the small clamping knob (22).
STORAGE BAG (Fig. 9)
A canvas storage bag (9) comes with the router
table (A). The storage bag can be mounted to
the outside or the inside of the left or right leg
assembly.
1. Pull apart each hook and loop strap
attached to the storage bag (9).
2. Feed each strap through the slots in the
left or right leg assembly (8 or 10).
3. Secure the storage bag (9) to the leg
assembly (8 or 10) by pressing each hook
and loop strap together.
Router Table Setup
NOTE: Use the scale on the tabletop as a guide
when aligning the fence for routing operations.
Once the fence is positioned and aligned correctly,
tighten the clamping knobs SECURELY.
FIG. 8
FIG. 9
12
C
FIG. 7
Router removed for clarity
21
20
26
8
9
18
32
J-slot
8
1
22
29