Skil RAS800 Consignes De Fonctionnement/Sécurité page 13

ensure that the table legs are fully extended
and in the locked position. The entire unit
(router table with router) is placed on and
secured to a solid, flat, level surface that will
not tip. Such precautionary measures reduce
the risk of table shifting unexpectedly while in
use resulting in property damage or serious
personal injury.
HELPFUL TOOLS AND PARTS
(not included)
•
C-clamps
METHOD 1 (Fig. 10)
1. Set router table (A) on a workbench or other
stable surface, with the FRONT (switch side)
of the router table facing towards you.
2. Using the clamping bosses on the router table
legs (8 and 10), secure the router table legs to
the workbench with clamps. Be sure to tighten
them securely.
IMPORTANT: Be sure the placement of the
clamps will not interfere with operation of the
router table.
METHOD 2 (Fig. 11)
1. Set the router table (A) on a workbench or other
stable and sturdy surface, with the FRONT (switch
side) of the router table facing towards you.
2. While holding the router table in the desired
position, mark the location of the four mounting
holes (two on each leg assembly [8 and 10]).
3. Remove the router table (A) from the workbench
and set it aside.
4. Drill suitable pilot holes (for wood screws) or
through-holes (for machine screws) at the
marked locations.
5. Place the router table (A) on the workbench and
align the mounting holes in the router table legs
(8 and 10) with the holes drilled in the
workbench.
6. Secure the router table (A) in place using the
wood screws and washers (not provided).
Router Table Setup
MOUNTING THE ROUTER TABLE TO A
WORK SURFACE OR WORKBENCH
Before operating the
router in the router table,
•
Phillips screwdrivers
•
Small adjustable wrench
•
Electric or hand drill with drill bits
(depending on mounting method used)
•
Fasteners
— 4 #10-16 x 3/4" pan-head wood screws
and 4 washers (for solid wood surfaces
or workbenches)
OR
— 4 3/16" pan-head machine screws,
8 washers, and 4 hex nuts
FIG. 10
8
FIG. 11
8
If using wood screws, applying a thin coat of
soap to the screw threads will make it easier to
thread the screws into the pilot holes.
7. TIGHTEN all screws SECURELY.
13
A
10
A
10