Mono-Light Regulation - solamagic S1 Manuel D'instructions Et D'installation

c) Mono-light regulation:
Switching on/off:
Dimming:
Start-up:
Auto-stop:
Memory function:
Comfort switch:
Synchronisation:
08/2016
Brief pressing of the programmed key on the hand-held
transmitter switches the wireless receiver on or off.
Pressing and holding the programmed key on the hand-
held transmitter causes the dimmer to change the bright-
ness up to the maximum or minimum setting.
Pressing and holding the programmed key on the hand-
held transmitter in the switched off state causes the dim-
mer to increase the brightness up to the maximum value.
The dimmer stops automatically upon reaching the ma-
ximum or minimum position, even if the key remains
pressed.
Upon switching back on, a short press of the key recalls
the last set tandem value.
In addition to light control via the hand-held transmitter,
the light can be switched off and on again via a domestic
wiring switch fitted as necessary. When switching on with
the domestic wiring switch, the brightness value is always
called that applied when the receiver was last switched off
with the hand-held transmitter.
If multiple receivers are controlled using the same hand-
held transmitter, faults in the wireless transmission path
can result in different brightness levels. The function
„Start-up" first switches on all receivers and then synchro-
nises them with special „Neutral value" function.
28