Publicité
Les langues disponibles
Les langues disponibles
CEFL50FH ELECTRIC APPLIANCE
Wall-Mount Installation
Due to the many different materials used on different walls, it is highly
recommended that you consult your local builder before you install this
appliance on the wall.
A.
Select a location that is not prone to moisture and is located at least 36"
(91.4cm) away from combustible materials such as curtain drapes, furniture,
bedding, paper, etc.
B.
Have two people hold the appliance against the wall to determine the fi nal
location.
C.
Place unit face down on a soft, non abrasive surface. Remove the bracket
from the back of the unit by removing the screws, refer to Figure 1.
D.
Mark out location, then mount the bracket(s) onto the wall using the
supplied screws. This bracket MUST have the hooks facing upward and be level.
note:
It is strongly recommended that the mounting bracket be screwed into the wall studs where possible. If the wall studs
cannot be used, ensure that the supplied plastic anchors are used to affi x the bracket to the wall and the bracket is
adequately secured.
E.
With the wall mounting bracket
installed, have two people lift the
appliance up and insert the two
hooks on the bracket into the two
slots on the back of the appliance.
F.
Check the appliance for stability
ensuring that the bracket will not
pull free from the wall.
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada •
(see installation manual for all installation options)
HOOK
GLASS FRONT
SIDE VIEW
FLOOR
SCREWS
1(866)820-8686
•
BODY
21 5/8"
55cm
HOOK
W415-2823 / 12.11.19
www.napoleon.com
Publicité
