Grundig MC 6840 Mode D'emploi page 24

PREPARATION ____________________________
Thinning plate button
In order to push out or insert thin
comb, you can choose to move the
button for thinning plate from back
to front or from front to back.
OPERATION ______________________________
Hair trimming
Make sure that the hair is clean and
completely dry.
Place a towel around the neck and
shoulders of the person whose hair
you are trimming. Make sure that
the person is seated so that their
head is roughly at your eye level.
Before trimming, comb the hair so
that it falls naturally and you can
see the direction in which it grows.
1 Adjust the trimming length by refer-
ring to the "Preparation" section.
2 Press the On/Off switch
switch on the appliance.
3
Place the cutting head
person's hair.
4
Move the cutting head
the direction of hair growth. Apply
only a slight pressure when cutting
with slow, gentle movements.
5
After use, switch off the appliance
with the On/Off switch
24 ENGLISH
C
Useful tips
Always cut against the natural
7
direction of the hair.
As you cut, take a break at regu-
7
lar intervals. You can always
make a correction, but not once
the hair has been cut.
Only cut a small amount the first
7
time you use it. This is the only
way to get used to the variable
positions.
Keep combing the hair. Only
7
look for hair which is too long
and comb out clippings.
to
E
Beard trimming
on the
B
1
Adjust the trimming length by refer-
ring to the "Preparation" section.
against
B
2
Press the On/Off switch
switch on the appliance.
3
Place the cutting head
beard.
.
E
to
E
on the
B