Trouble Shooting - Klarstein 10028741 Mode D'emploi

3. Put the filter system into white vinegar for about 10 minutes.
4. Take the filter system away from the white vinegar; shake for several times, clean it with clear water.
5. Make it dry. Pack it into a polybag. Keep it in a cool and shady place.
Method B:
1. Clean and activate the ceramic balls after use for 1000 l of water regularly.
2. Take the filter system away from the tank cover.
3. Put out the ceramic balls and clean it with clear water.
4. Sun them for several hours under sunshine.
5. Put ceramic balls back to filter cartridge.
6. Pack it into a polybag. Keep it in a cool and shady place.
Problem
Power lamp off, Device does not
work
Power lamp on, no mist outlet
with wind
Abnormal smell of mist
Power lamp on, unit does not
work
Too little fog.
Abnormal noise.

Trouble shooting

Possible reason
No power supply
No water in water tank
Security switch is too loose.
The unit is new.
Dirty or stagnant water.
There is too much water in the
water basin.
To much scale in the water basin.
Water that is too dirty or stagnant.
Resonance in water tank when
there is too little water.
Unit is on an unstable surface.
Solution
Connect device to power supply,
switch on
Fill water into water tank
Make the switch tight.
Take out the water tank, open the
cover, let it stay in a cool position
for 12 hours.
Clean the water tank. Fill in clean
water.
Remove some water from the
water basin. Close the cover of the
water tank tightly.
Clean the transducer.
Clean the water tank. Refill with
fresh water
Refill tank with water.
Move the unit to a stable and flat
surface.
16