Mögliche Störungen - ATIKA KS 2403/40 Notice Originale

Possible faults
Before each maintenance and cleaning work
− switch off device
− wait for stop of chain saw
− pull out main plug

After each fault clearance, put into operation and recheck all security installations.
Fault
Chain saw does not initiate
after switching on
Chain saw works with inter-
ruptions
Chain saw picks, vibrates or
does not saw correctly
Chain saw does not work
with full power
Saw chain gets hot
no saw chain lubrication
In case of further faults or inquiries please contact your local dealer.
Possible cause
 Chain brake
 no power
 Extension cable damaged
 Main plug, motor or switch defect
 external loose connection
 internal loose connection
 Circuit closer/breaker defect
 Chain edgeless
 Chain worn
 Chain tension
 Chain not assembled correctly
(teeth face to wrong direction)
 Extension cable too long or diame-
ter too small
 Power outlet to far away from main
connection
 no oil in the tank
 oil flow canal blocked
 chain tension too high
 Chain edgeless
 no oil in the tank
 oil flow canal blocked
Removal
 Release chain brake
 Check power supply, power outlet, fuse protection
 Check extension cable, exchange defect cable immedi-
ately
 Have motor or switch checked by an approved electri-
cian or replaced by original spare parts.
 Check power supply, power outlet, fuse protection
 Check extension cable, exchange defect cable immedi-
ately
 Please contact the after sales service
 Please contact the after sales service
 Chain must be regrinded or exchanged
 Exchange chain
 Check and adjust chain tension
 Assemble chain again
 Use extension cable with sufficient diameter
 Use power outlet which is nearer within the working
area
 Refill oil (Section "Chain lubrication")
 Clean oil flow canal
 Adjust chain tension
 Chain must be regrinded or exchanged
 Refill oil (Section "Chain lubrication")
 Clean oil flow canal
25