table of contents
EN
1.0
general information
2.0
2.1
access panel
2.2
burner assembly
2.3
2.4
2.5
2.6
2.7
2.8
2.9
3.0
3.1
3.2
4.0
4.1
4.2
log burner assembly (NG)
4.3
log burner assembly (P)
note:
The information throughout this manual is believed to be correct at the time of printing. Wolf Steel Ltd. reserves
the right to change or modify any information within this manual at any time without notice. Changes, other than
editorial are denoted by a vertical line in the margin.
WARNING:
!
which are known to the State of California to cause cancer, and chemicals including carbon
monoxide, which are known to the State of California to cause birth defects or other reproduc-
tive harm. For more information, go to www.P65Warnings.ca.gov.
1.0 general information
This burner and log assembly are approved for use in the HDX52 gas appliance only. They are not approved for
use as a stand alone appliance or in conjunction with any other appliance.
2.0 installation
2.1
access panel
A.
Remove the door,
refer to installation
instructions.
Remove the 8
securing screws
and lift the plate
up and out of
the appliance.
Gasket will need
to be replaced if
damaged.
2.2
burner assembly
A.
Attach the burner assembly to the fi rebox
base with the 2 screws supplied.
2
W415-2746 / A / 11.04.19
This product can expose you to chemicals including lead and lead compounds,
OUTSIDE APPLIANCE
INSIDE APPLIANCE
2
2
2
2
3
4
5
7
7
7
7
8
8
8
9
9
10
11