Cleaning And Sterilising; Charging - Tommee Tippee made for me Mode D'emploi

To assemble, choose your preferred horn / flange (24mm or 28mm nipple / teat
diameter) and insert into the pump body (1).
With the collector bottle components assembled, clip in to the bottom of the pump
body (2).
H, I, J, G, K assembly
b. Cleaning and sterilising
Your wearable breast pump must be cleaned and sterilised before first use. Always
disassemble components before cleaning or sterilising.
All of the parts intended for washing can go in top rack of dishwasher and can be
sterilised (microwave, steam, UV, rolling boil). See table below. The pump body (F)
should not be washed or sterilised. It contains electronics that must be kept dry. Please
use a clean, damp cloth to wipe as required.
c. Charging
It's important to fully charge your pump when the battery is low (indicated by
a red light).
When charging the pump, wait for the battery light to turn green. This indicates that the
pump is fully charged and ready to use. The pump cannot be used whilst charging.
You should only use the cable and plug provided with this product. A full charge offers
up to 4 hours of use per pump. Please make sure the device is turned off before plugging
in the USB cable to charge. The device turns off automatically after 10 minutes of idle time.
1.
(A/B) Horn
2.
9