Operating Instructions - Allen + Roth 2317FM-33-202 Mode D'emploi

OPERATING INSTRUCTIONS

Control Panel
M
Note: The control panel is a touch screen. It will appear black. Touch the control panel once to "wake up" the
controls. This will cause the controls to light up. Whichever icon you touch will display its last setting when
you do this. At this time, you can press the corresponding icon to the function you would like to adjust. After 5
seconds the touch screen will fade to black.
Power Function
M • Press the POWER ICON to turn the main power to the unit ON or OFF.
• When the unit is powered ON, the lights under the ember bed will glow to indicate the unit has
power.
• If any functions are stored in memory then they will resume at the last setting.
Flame Brightness Function
• Press the FLAME BRIGHTNESS ICON to adjust the flame brightness.
• If the unit main power is OFF, you can press the FLAME BRIGHTNESS ICON to power ON the unit
and flame brightness will resume at the last setting.
• Press the FLAME BRIGHTNESS ICON again to scroll up through the flame brightness settings: 1, 2,
3, 4, 5, OF.
Temperature Function
• If the unit is powered OFF, you can press the TEMPERATURE ICON to power ON the unit. The
ember bed will glow at the lowest brightness setting unless a different setting was saved in the
memory.
• Press and hold the TIMER ICON for 5 seconds to toggle between 5°F (3°C) increments and 1ºF
(1°C) increments when setting the temperature. The factory default temperature is 5°F (3°C)
increments.
Note: This option is only available if using the control panel.
• Hold down the TEMPERATURE ICON for 5 seconds to toggle between Fahrenheit and Celsius. An
"F" or "C" will display next to the temperature.
Note: This option is only available if using the control panel.
• Press and hold the TEMPERATURE ICON for 10 seconds to disengage the heater function. Press
and hold the TEMPERATURE ICON for 10 seconds again to engage the heater function. (See
HEATER OVERRIDE section below for more details).
Increase/Decrease Button
Note: This option is only available if using the remote control.
• Press the INCREASE/DECREASE button to adjust the heater's thermostat setting.
• Press the INCREASE/DECREASE button again to scroll up through the pre-set temperature
settings: The thermostat setting range is 65°F (18°C) to 90ºF (32°C), HI (High).
• Set the temperature to "HI" to have the heater run continually.
Remote Control
To use the remote control, first insert two
AAA batteries (included) into the remote
control. Ensure the polarities of the
batteries match the inside of the battery
compartment.
15
AAA 1.5V
AAA 1.5V