Allen + Roth 2317FM-33-202 Mode D'emploi page 11

ASSEMBLY INSTRUCTIONS (CONT'D)
9. Insert shelf pins (EE) at desired height,
ensuring they are level. Place shelf (I) on top of
shelf pins (EE).
Repeat for remaining the shelf (I).
Hardware Used
Shelf Pin
EE
10. Install the doors
I. Loosen the screws on the hinge arms and plates pre-attached on the walls (E and F).
II. Pick up left door (G) and attach it to left outer wall (E) by engaging both door hinges
simultaneously. Please follow the steps below to combine the door hinges together.
i. Extend both hinge arms on the left door (G) to open position.
ii. Insert the "J" hooks beneath the hinge arms into the lugs on mounting plates pre-attached
on left outer wall (E).
iii. Press lightly on the end of both hinge arms to engage the catch.
iv. To remove the hinge arms from the mounting plates, press gently in the release lever on the
back of hinge arms.
III. Once assembled, go back and fully tighten all screws.
IV. Repeat the same procedure to attach the other right door (H) at the opposite side.
V. Open and close the doors to make sure they are aligned and shut correctly. If necessary,
adjust the screws for a good fit.
10
E
G
9
x 8
I
I/F
F
II
(i)
H
III
11
EE
Release lever
(iii)
(ii)
"J" hook