Features - Master SilentDrive MH-150T-SDR Manuel De L'utilisateur Et Mode D'emploi

Wheel
Fuel Gauge
1. Insert axle through holes in wheel support.
2. Slide then spacer onto axle.
3. Slide wheel onto axle and hold in place with the axle
nuts. (See Figure 1).
Wheel Support Frame
Tire
Axle Nut
4. Place heater on wheel support frame and line up holes
on the fuel tank lip.
5. Attach front handle with (4) long screws
(50 mm) and (4) nuts through the second and third
hole from the front on both sides of the tank lip and
wheel support frame and tighten firmly.
6. Insert (2) short screws (30 mm) through the first hole the
front of in the tank lip and tighten firmly. Make certain
all (6) screws are secure.
7. Attach rear handle with (4) long screws (50 mm) and (4)
nuts through the first and second hole from the rear on
both sides of the tank lip and wheel support frame and
tighten firmly.
8. Attach front guard with the included hardware.
© 2021 Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR
WHILE CONNECTED TO A POWER SOURCE

FEATURES

Fuel Cap
ASSEMBLY INSTRUCTIONS
Models: 150T-SDR / 220T-SDR
Axle
Spacer
Figure 1
Shell Control Panel
Fuel Tank
Safety Guard
Figure 2
5
Silent Drive Forced Air Heater User's Manual
Rear Guard
Handle
Power Cord
Support Frame
Drain Bolt
Handle
Wheel Support Frame