MBM PQ9T Serie Manuel D'installation Et D'utilisation page 25

safety of the appliance and must
therefore be performed by techni-
cal personnel of the manufacturer
or by technicians who are formally
authorised by the same. Failure to
do so exempts the manufacturer
from any liability for for any possible
resulting modifications or damage.
Upon arrival, check the inte-
grity of the appliance and its
components
cord), prior to use. In the presence
of faults do not start the appliance
and contact the nearest service
centre.
Read the instructions before
acting.
tions to be performed. As far as
personal protective equipment is
concerned, the European Com-
munity has issued Directives
which the operators must comply
with. Noise ≤ 70 dB.
It is forbidden the installa-
tion of stand alone equip-
ment WITHOUT anti-tip kit
(ACCESSORY). TOP versions
excluded.
Before making the con-
nections check the technical
data shown on the rating
plate of the appliance and the te-
chnical data in this manual. It is
strictly forbidden to tamper with
or remove the plates and picto-
grams applied to the equip-
ment.
Disconnect all supplies, if
present (e.g. water - gas -
electrical) upstream the ap-
pliance whenever you need to
work in safe conditions.
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
GENERAL AND SAFETY INFORMATION
(e.g. power
Wear protective
equipment suita-
ble for the opera-
- 5 -
Connect the appliance if pre-
sent, in the sequence of the
water, then to the gas network.
Ensure there are no leaks then
proceed with the connections to
the mains.
The appliance is not desi-
gned to work in an explosive
atmosphere and as such its
installation and use is categorical-
ly prohibited in such environmen-
ts.
Position the entire structure,
respecting the installation di-
mensions and characteristics
indicated in the specific chapters
of this manual.
The appliance is not intended
for recessed installation. /
The appliance must be used
in a well ventilated area. / The ap-
pliance must have free drainage
(not hindered or impeded by forei-
gn bodies).
The gas equipment must be
installed beneath an extrac-
tion hood whose system
must have specifications in compli-
ance with the current regulations in
the country of use.
Once the appliance is con-
nected to the power and
drain sources, it must remain
static (fixed) in the place of use
and maintenance. Incorrect con-
nection may cause danger.
Use where appropriate flexi-
ble cable for connection to
the mains electricity supply
with characteristics not inferior to
the type with insulation model
H07RN-F. The supply voltage sup-
ported by the cable with the ap-
pliance working must not differ
2.
EN