Publicité
Step 20
Carefully turn your unit over onto its front edges. Unfold the LARGE BACK (P) and lay it over your unit.
å
Make equal margins along all four edges of the LARGE BACK (P). Push on opposite corners of your unit if needed to make
å
it "square".
Fasten the LARGE BACK (P) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over the HUTCH SHELVES (L and M) and HUTCH UPRIGHT (G).
å
NOTE: Perforations have been provided for access through the BACK.
å
Unfold the SMALL BACK (Q) and lay it over the lower section of your unit.
å
Make equal margins along three edges of the SMALL BACK (Q) with the tabs between the LARGE BACK (P)
å
Fasten the SMALL BACK (Q) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over the UPRIGHT (E).
å
NOTE: Perforations have been provided for access through the BACK. Carefully cut out the rectangle in the BACK for
å
proper ventilation of your CPU.
Tighten two TWIST-LOCK® FASTENERS in the MODESTY PANEL (J).
å
NAIL
(73 used in this step)
For support, place packing
foam and magazines here.
www.sauder.com/services
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
1N
Tabs
These holes must line up over the HUTCH
SHELVES (L and M) and HUTCH UPRIGHT (G).
P
Q
415109
Ventilation cut-out should be here.
Tighten two
J
TWIST-LOCK®
FASTENERS
These holes must line up
over the UPRIGHT (E).
Page 25
Publicité
