Sauder 415109 Instructions De Montage page 11

Step 6
Separate the EXTENSION SLIDES (EE) from the
å
EXTENSION RAILS (DD) as shown in the upper diagram
below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (DD) to the RIGHT END (A)
å
and RIGHT UPRIGHT (E). Use four GOLD 5/16" FLAT
HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into
å
the hole shown in the enlarged diagram. Then, slide the
innercartridge of the EXTENSION RAIL in to fi nd the other
hole that lines up with the hole in the RIGHT END (A) and
RIGHT UPRIGHT (E). Turn a SCREW into these holes.
Push the black lever in and pull the SLIDE from the RAIL.
Open end
www.sauder.com/services
EE
E
DD
DD
A
415109
Open end
DD
3S
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
Page 11