Sauder 415109 Instructions De Montage page 14

Step 9
Fasten the HUTCH LEFT END (D) to the LEFT TOP
å
MOLDING (BB). Tighten two TWIST-LOCK® FASTENERS.
Insert eight METAL PINS (1R) into the SMALL
å
PINNED UPRIGHTS (T).
Push the METAL PINS in the edges of the SMALL PINNED
å
UPRIGHTS into the holes in the TOP (I).
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the
adjoining part.
NOTE: The dowel end of the FASTENER must remain fully
inserted in the hole of the adjoining part while locking the
FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight
as possible.
D
Page 14
® FASTENER
Dowel end
BB
T
T
1R
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
1R
I
Finished edge
415109
Caution
www.sauder.com/services