Axis P3353 Guide D'installation page 17

AXIS P33 Network Camera Installation Guide
Unit connectors
Note:
AXIS P3353 and AXIS P3354 do not support audio or I/O.
Network connector - RJ-45 Ethernet connector. Supports Power over Ethernet.
Due to local regulations or environmental and electrical conditions in which the product is to be
used, a shielded network cable (STP) may be appropriate or required. Network cables that are
routed in outdoor environments or similar shall be shielded (STP) and intended for their specific
use. Make sure that the network switch is properly grounded. See Electromagnetic Compatibility
(EMC) for regulatory requirements.
Audio in - 3.5mm input for a mono microphone, or a line-in mono signal (left channel is used from
a stereo signal).
Audio out - Audio output (line level) that can be connected to a public address (PA) system or an
active speaker with a built-in amplifier. A pair of headphones can also be attached. A stereo
connector must be used for the audio out.
SDHC memory card slot - The SD memory card can be used for local recording with removable
storage.
I/O terminal connector - Used in applications for e.g. motion detection,
event triggering, time lapse recording and alarm notifications. In addition to
an auxiliary power and a GND pin, it provides the interface to:
• 1 transistor output - For connecting external devices such as
relays and LEDs. Connected devices can be activated by the
VAPIX® Application Programming Interface (API), by the output buttons on the Live
View page or by an Action Rule. The output will show as active (shown under System
Options > Ports & Devices) if the alarm device is activated.
• 1 digital input - An alarm input for connecting devices that can toggle between an
open and closed circuit, for example: PIRs, door/window contacts, and glass break
detectors. When a signal is received the state changes and the input becomes active
(shown under System Options > Ports & Devices).
Function Pin
GND 1
3.3V DC 2
Power
Digital 3
Input
Digital 4
Output
Notes
Ground
Can be used to power auxiliary equipment.
Note: This pin can only be used as power out.
Connect to GND to activate, or leave floating (or
unconnected) to deactivate.
Uses an open-drain NFET transistor with the
source connected to GND. If used with an
external relay, a diode must be connected in
parallel with the load, for protection against
voltage transients.
Page 17
Pin4 Pin2
Pin3
Pin1
Specifications
Max. load = 50mA
Min. input= 0 to - 40V DC
Max. input= 0 to + 40V DC
Max. load = 100mA
Max voltage = + 40V DC