Napoleon DLKIX4 Guide Rapide

maximum glowing effect. Log colours may vary. During the initial use of the appliance, the colours will become
more uniform as colour pigments burn in during the heat-activated curing process."
Insert only if
applicable ---->
WARNING
!
Log Number
• Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
1
with this appliance may result in property damage or personal injury.
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
2
appliance may not function properly and delayed ignition may occur.
3
• The logs are fragile and should be handled with care.
4
5
PHAZER™ logs and glowing embers, exclusive to Napoleon, provide a unique and realistic glowing effect that is differ-
"PHAZER™ logs [and glowing embers], exclusive to Napoleon/Continental, provide a unique and realistic
ent in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect. Log colours
6
glowing effect that is different in every installation. Take the time to carefully position the glowing embers for a
may vary. During the initial use of the appliance, the colours will become more uniform as colour pigments burn in during
maximum glowing effect. Log colours may vary. During the initial use of the appliance, the colours will become
7
the heat-activated curing process.
more uniform as colour pigments burn in during the heat-activated curing process."
8
9
Insert only if
applicable ---->
10
Log Number
note:
1
The E1 stud must be removed from the burner tray before beginning installation. See illustration below.
2
3
Burner Ports
4
5
Stud
6
(Log #1)
7
8
9
IF APPLICABLE, INSERT DRAWING OF BURNER/SUPPORT WITH APPROPRIATE LA-
10
Stud
(Log #2)
IF NOT APPLICABLE, HIDE THIS SECTION AND USE BOXES BELOW.
Burner
Tray
IF APPLICABLE, INSERT DRAWING OF BURNER/SUPPORT WITH APPROPRIATE LA-
IF NOT APPLICABLE, HIDE THIS SECTION AND USE BOXES BELOW.
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON L4M 0G8 Canada
note:
DLKIX4 Driftwood Log Placement
Log numbers are located on the bottom or back of the logs.
Part Number
If applicable, insert the following statement:
note:
Log numbers are located on the bottom or back of the logs.
Part Number
Pilot Shield
A1
BELS (I.E. STUDS, PILOT SHIELD, BURNER PORTS, ETC.).
B1
C1 C2
Studs
(Log #3)
BELS (I.E. STUDS, PILOT SHIELD, BURNER PORTS, ETC.).
Burner Overview
1
Description
Description
Stud
(Log #1)
A2
B2
D1 D2
Studs
(Log #4)
Notch
1(866)820-8686
2
Upper Burner
Support
Stud
(Log #2)
E1
Burner
Ports
W415-2810 / A / 07.28.20
www.napoleon.com
1