PROBLEM
LCD shows 'FILL
TANK' when there
is water in the tank
Brew doesn't start
Showerhead falls out
The mesh filter
in the water tank
loosens and floats
Carafe drip stop
stays down
Unit produces
excessive steam
while brewing or
runs for extended
periods with only
steam output
'DESCALE' on LCD
screen (flashing)
Unit shows "too hot"
OVER ICE and
COLD BREW modes
are disabled
A small amount of
water remains in the
tank after brewing
BDC450_455_USC_IB_I20_FA.indd 21
POSSIBLE CAUSE
•
Check that the unit is not in direct
sunlight or direct bright lighting.
•
There is no water in the water tank.
•
Each brewing mode has different
water amount limits, and it does not
brew when the amount is beyond
the limit.
•
The showerhead may loosen and
fall out from time to time if not
inserted or tightened correctly.
•
Mesh filter is not inserted or
tightened correctly.
•
The drip stop is stuck.
•
Brewing performance is affected by
scale accumulated by hard water.
•
Brewing temperature profile is not
properly set.
•
Brewing performance is affected by
scale accumulated by hard water.
•
Unit has been run too many times
back to back and the components
are overheated.
•
If the water is more than 20oz /
600ml, these modes are disabled.
•
This is part of the normal operation.
WHAT TO DO
•
Move unit away from the light source.
•
Check that the water tank is filled.
•
Check the water amount limits for
each mode.
•
Please wash the showerhead ring and
seal and re-insert.
•
Call Breville Consumer Support.
•
Pull the drip stop back up.
•
Clean the drip stop for any foreign
objects of coffee grinds or stains.
•
If the problem persists and drip stop
does not return to top position please
call Breville Consumer Support.
•
Descale the unit.
•
Call Breville Consumer Support if
problem persists.
•
Descale the unit.
•
Let unit rest for at least 20mins before
starting another cycle.
•
Reduce the amount of water
in the tank.
•
No user action required, continue
normal use.
21
24/1/20 9:48 am