Sonia Tyl Mode D'emploi page 5

bottom of the "extendable column". Then place
everything onto the "base for the 5 feet" and
press down until properly fitted.
Finish this step by screwing in the "base clamping
plate" with the "attachment kit".
4
- Step : Place the "main unit" onto the "column
anchor bracket" to complete assembly.
- To install or remove the water tank, disconnect
the steamer from the mains. If it has been used
recently, wait for the water to cool down before
removing it.
- Always hold the tank by the plastic handle. Turn
the knob one way or the other according to the
attached image and move it to the side in order to
remove or reinstall the tank.
- Make sure the tank is properly centred before
tightening the knob again.
● Operation
- Fill the water tank by opening the steamer filler
cap and pouring in distilled water. The water level
must remain between the "MIN" and "MAX" lines.
Once filled, replace the cap.
- Add essential oils by opening the sliding lid at
the top of the arm head nozzle and dropping one
or two oil drops onto the cotton.
- Never add essential oils directly into the water
tank.
CONTROL PANEL
1 2 3 4 5 6 7 8 9 10 11 12 13
1 Water-level warning indicator
2
Ozone function indicator
3 Ozone function on/off button
4
Power on indicator
5
On / off button
6
Decrease time button
7
Timer
8
Increase time button
9
Heating indicator
10 Heating/Steaming button
11
Steaming indicator
12 Steam volume adjustment button
13
Steam volume indicator
EN
5