Publicité
To avoid distortion or mismatching that could damage the device,
the audio connecting plug (white or red) may only be connected to
an audio cinch input.
The video connecting plug (yellow) may only be connected to a
video cinch input.
If you are not clear about the correct connection, contact our
technical support or another specialist.
For any extension, only use the shielded cinch cables suitable for this. The
use of any other cable may cause interference. Keep the length of the cable
as short as possible.
Initial operation
• Insert the plug-in power units of the radio camera system into the mains sockets.
The receiver is now in operation the operating display (17) lights up.
• Switch on the surveillance monitor. Select the input on the surveillance monitor to
which the receiver of the radio camera system was connected (usually "AV").
• Connect the camera as described under "Connecting the radio camera". The cam-
era is now ready for use.
• Set the channel selection switch (8) of the radio camera and the one on the receiv-
er to the same transmission channel.
Channel selection on the camera:
To set the channel selection switch (8) on the radio camera, proceed as follows:
- First of all open the protective covering (starting at the left).
- Please take a pointed object, e.g. a ballpoint pen and slide the channel switch
into the desired channel position (CH1/CH2/CH3).
- Close the protective covering again carefully (water protection).
28
All manuals and user guides at all-guides.com
• This camera system creates, uses and radiates high-frequency energy. If the
devices cannot be installed and operated as stated in the instructions, disturbance
to other devices could be the result. If the radio camera system should disturb oth-
er devices, it is the duty of the operator to stop this through one or several of the
measures listed below:
- alter the position of the radio camera
- increase the distance between the disturbed device and the radio camera or the
receiver of the radio camera system
- select another transmission channel
• The use of the radio camera system cannot replace personal supervision of a child
or those in need of care etc. but only support this.
• Do not leave the packaging material lying around carelessly. Plastic foil and/or bags
and polystyrene parts etc. can become dangerous toys in the hands of children.
Scope of delivery
Radio camera with integrated transmitter
Radio receiver
(2) Plug-in power units
AV cinch cable
Tripod wall-fastening unit with ball and socket joint and fastening material
Operating instructions
Setting up the devices and connection
Find a suitable place for mounting at the place from which the desired object is to be
observed.
A suitable place for mounting has the following features:
• as free from dust as possible
• little vibration
• good circulation
• there is a mains socket in the proximity
25
Publicité
Chapitres
