Reversing The Door - LG DLE5001W Mode D'emploi

REVERSING THE DOOR

Hole cap
1
Open the door and remove the two plastic
hole caps on the catch side by gently prying
up with a flat blade screwdriver. Save these
for step 6.
CAUTION
Support the weight of the door when removing
the screws in the next step. Failure to properly
support the weight of the door could result
in property damage, damage to the dryer, or
personal injury.
Hinge Screw
2 While supporting the door, remove the 4
screws, two from each hinge. Set the door
aside face down on a protected surface to
prevent damage to the door or the work
surface.
inner door frame
3
With the door on a protected surface,
remove the 12 screws on each side of the
door and lift off the inner door frame using
a flat blade screwdriver. Remove the latch
hook and blank and move them to the
opposite side.
12
latch hook
4 Remove the 4 screws securing the hinges to
the door frame. Remove the two plastic cover
caps. Reinstall the hinges and cover caps on the
opposite sides from which they were removed.
5
With the hinges and cover caps in the new
locations, remount the inner door frame
onto the outer door frame with the screws
removed in step 3 above.
6
Reinstall the door with the screws from step
1,2.
Swing Door
7
Test the swing of the door to make sure the
hinges and latch are properly aligned and that
the door closes and latches correctly.
Hinge
assembly
Cover cap