Drawer And Cover Removal; Light Bulb Replacement - GE TPG21BRDABB Mode D'emploi

Drawer and Cover Removal

Drawers at the bottom of the fresh food compartment will stop
before coming all the way out of the refrigerator, to help prevent
contents from spilling onto the floor. These drawers can be removed
easily by lifting the sides up slightly while pulling the drawers past
the ''stop'' location.
Twin Drawers with Glass Cover
To remove the glass cover:
1. Remove the drawers.
2. Reach in, push the front of glass cover
up and, at the same time, pull it forward
as far as it will come.
Tilt it and take it out. Avoid cleaning the
cold glass cover with hot water because the
extreme temperature difference may cause
it to break.

Light Bulb Replacement

A light bulb and socket are located at the top of the fresh food
compartment opposite the temperature control panel.
To replace the bulb, first unplug the refrigerator from its electrical
outlet. Put your hand under the light shield and release the hook at
the bulb end of the shield. (The light shield is on some models.)
(on some models)
(on some models)
Full-Width Drawer with Plastic Cover
(on some models)
To remove the cover, lift it off
its supports, pull it forward,
tilt it and take it out.
3. Remove the drawer frame. (Always remove the glass cover before
you take out the drawer frame.)
Lift the frame off the supports at each side and back, pull it forward,
tilt it and take it out.
To replace the glass cover:
1. Lower the frame until it rests on the supports at each side and back.
2. Replace the glass cover, pushing its rear edge firmly into the rear
frame channel and gently lowering the front into place.
3. Replace the drawers.
Squeeze to
release the hook
9