Shelves - GE TPG21BRDABB Mode D'emploi

FRESH FOOD COMPARTMENT SHELVES
Half-Width Shelves
One end of the shelf rests on
a molded side-wall support;
a bracket on the other end
hooks into a track on the rear
cabinet wall.
To remove, lift the shelf up at
front, then off the support and
out of the track.
To replace, select desired shelf
height. With shelf front raised
slightly, hook the bracket's top
lug into the track, then lower
the shelf onto the support.
Full-Width Shelves
Some models have a steel wire sliding shelf, a stationary tempered
glass shelf or two steel wire stationary shelves. These shelves can be
moved to another place in the fresh food compartment.
The full-width sliding shelf has
stop-locks. When placed correctly on the
shelf supports, the shelf will stop before
coming completely out of the refrigerator
and will not tilt when you place food on it or
remove food from it.
4
Shelf supports at various levels allow you to custom-space shelves
(on some models)
2
Lift up
and out
1
(on some models)
NOTE: The shelf to the right of the track is
designed to hook into the right-hand slot; the
shelf to the left is designed to hook into the
left-hand slot.
Tilt up
To remove a full-
width shelf.
Lift the rear of the shelf
and pull forward.
To remove a full-
width shelf when the fresh food
compartment door cannot be
opened fully... lift the rear of the
shelf, pull forward and down, tilt the
shelf and take it out.