Regular Maintenance Procedures - Master Spas INT MP Impact Manuel De L'utilisateur

Regular Maintenance Procedures

Note: These are maintenance procedures are the responsibility of the swim spa owner to perform.
These procedures are not covered by the swim spa warranty.
CLEANING JETS
The majority of jets in your swim spa can individually be turned on/off. If any of these jets become
hard to turn, it will be necessary to remove the jet to clean it as grit/sand and mineral deposit may
be present.
The jets in your swim spa can be removed for cleaning by unscrewing them (counter clockwise)
and then pulling out the jet.
To Clean Jets
Place the jet(s) in a container, fully immerse in white vinegar. Let the jet(s) soak overnight and then
rinse with water. It may be necessary to clean grit and deposits from the white jet body (mounted
in the spa shell) by using a small bristled brush.
CLEANING DIVERTER VALVES
Mineral deposits, grit and sand may get into the internal parts of the diverter valves over time. The
diverter valves may become difficult to turn or not turn at all.
Remove the handle from the top of diverter valve by gently prying up on both sides of the handle
assembly at the same time.
Turn the cap piece counter clockwise. It may be necessary to put a clean towel over the cap and
turn it with a wrench.
Once loose, the cap and handle can be pulled up out of the white plumbing fitting.
Wipe down the internal piece that attaches to the cap and handle.
Soak the cap and handle in white vinegar.
The white plumbing fitting should also be wiped down. If the surface of the white plumbing has
become too abrasive, you can take wet, fine sandpaper and smooth it out. It is also helpful to use
a lubricant (use silicone based, not petroleum based) to allow for an easier turn of the diverter
handle.
Rinse the diverter internals and reassemble.
In the future, it is helpful to turn the diverter valve only when the pump is not on. Cleaning your
diverter valve should occur every time you drain your swim spa.
DRAINING YOUR SWIM SPA
Due to the physical size of the swim spa, we recommend draining your swim spa with a submers-
ible sump pump. Draining your swim spa with a conventional swim spa drain is not a reasonable
option. When draining the Momentum 80 swim spa always drain the water from the spa side
before draining the swim side.
DO NOT DIVE. DO NOT DIVE. 100 25