BST MOOVY Mode D'emploi page 6

Console de mixage amplifiee transportable

Les langues disponibles

20. MASTER AND MONITOR VOLUME CONTROLS

General Volume L & R : These two potentiometers are used to control the left and right levels of the main output.

Monitor volume : This potentiometer is used to adjust the level of the monitor output.

21. AUX INPUT

Connect this socket to the output of a cd player or a line items.

22. EFF OUTPUT

Connect this socket to the input of an extenral effect processor ( reverb, equalizer ,... )

23. MONITOR OUTPUT

This socket is used to connect a power amplifier to listen your mix on your stage. No amplified output.

24. LINE OUT OUTPUT

These sockets are used to plug a power amplifier to add one or more master speakers. No amplifed output.

25. FOOTSWITCH CONNECTORS

The foot switch connector is used to connect a standart foot switch to avalaible or to unable to effect function ( EFF/MUTE )

26. POWER SWITCH

Press this switch to turn the power ON, press again to turn the power OFF. When operating this switch, be sure that all controls are set at

minimum position.

27. POWER SOCKET ( WITH FUSE )

Plug the AC power cord into any standard AC outlet. Before plugging this cord in, be sure the voltage of AC outlet is correct.

The fuse is used to protect your power amplifier from different kinds of ac problems. If the power amplifier is "on" and nothing lights,

please verify the fuse compartment. If fuse is broken, please read it and change with a new one of same size and value.

28. SPEAKER OUTPUTS

Connect this output to your speakers ( these outputs are amplified )

APPLICATION :

On the mono XLR inputs, you can connect microphones or others peripherals with microphone level.

ON the mono Jack 6.35 inputs, you can connect instruments like guitar, keyboard,...

On the stereo RCA inputs, you can connect peripherrals with line inputs( CD player, minidisc player, VCD player or LD player )

You can record your mix if you connect a tape recored or a minidisc recorder to the REC output.

The monitor output is used to listen your mix in your working place without to be disturb by the main speakers. Connect the monitor

output to the input of a power amplifier then connect this power amplifier to your monitor speaker.

You can connect an external effect ( reverb, equalizer,... ). Connect your external processor to the EFF output.