Shaper ORIGIN S01-EN Guide D'utilisation page 16

Basics
Changing the Router Bit
To change router bits, first unplug the SM1 Spindle
from Origin and remove it from the spindle
mount, as described earlier. Press the collet lock
while loosening or tightening the collet locking
nut with the included 19mm wrench. Do not
tighten the collet locking nut until a router bit is
inserted.
WARNING: Maximum allowable cutter diameter is
1 inch (25 mm).
Powering Origin
Plug Origin into a grounded wall outlet, either
directly, or through a properly rated extension
cord, surge protector, or power strip.
WARNING: Do not plug Origin into the switched
outlet available on some dust extractors.
Unlike most power tools, Origin has an internal
computer, making these outlets unsuitable for
Origin.
8