Shaper ORIGIN S01-EN Guide D'utilisation page 15

Basics
Removing and Installing the SM1 Spindle
IMPORTANT: Always unplug the SM1 Spindle from
Origin before removing the spindle from the
spindle mount.
To enable unobstructed access to change the
router bit, the SM1 Spindle must be removed
from Origin. Use the included 4mm T-handle hex
wrench to loosen the spindle mount bolt. Once
loosened, lift the spindle to remove it.
To reinstall the spindle, slide it into the spindle
mount with the ON/OFF switch facing towards
you. A groove on the back of the spindle will only
allow it to be inserted in the correct orientation,
with the cable exiting on the left side. Gently
reinsert the spindle.
IMPORTANT: Be sure to tighten the spindle mount
bolt after fully inserting the spindle into the
spindle mount.
Finally, ensure the switch is in the "OFF" position
and plug the spindle cable back into the side
of Origin.
shapertools.com 7