Brizo RP75012 Instructions De Montage

This kit is intended for use on Brizo 3 and 6 function diverter models.
It extends the handle by 1 inch.
Este kit está diseñado para uso en los modelos de Brizo con desviadores
de 3 y 6 funciones. Extiende el mango 1 pulgada más.
Cette trousse est conçue pour être utilisée avec les modèles Brizo à
inverseur à 3 ou à 6 fonctions. Elle allonge la manette de 1 pouce.
A.
1
2
If the escutcheon has already been
A.
installed, it does not need to be removed.
Check the brass extender piece (1) in the
kit and make sure that the set screw is in
place but does not extend into the "D" open-
ing on the bottom of the stem. If it does,
simply back the set screw out enough so it
does not extend into the opening.
Align the "D" shape inside the extender
with the "D" on the diverter cartridge stem
and push it on until it stops. Tighten the set
screw (2) in the extender firmly against the
cartridge stem (3).
Note: A second extender piece (1) is
provided in the kit, and will be required to
obtain the full 1" extension (if two extend-
ers are used, one may need to be cut to
length to obtain the fit desired).
3/12/13
3
3/32"
RP75012
Extension Kit for Diverter Models
Kit de extensión para los modelos
con desviador
Trousse de rallonge pour modèles
à inverseur
B.
Install the handle per your original model
B.
installation instructions.
For assistance, call
1-877-345-BRIZO (2749)
1 75013 Rev. B