Brizo RP90243 Serie Manuel D'installation

NOTE: It is suggested that you anchor your shower arm or water lines.
Sotria
RP75722p
3
4
2
RSVP
RP48040p
3
2
Vettis
RP90243p
3
4
Levoir
RP92044p
3
4
6
www.brizo.com
Virage
RP62603p
1
SHOWERHEAD AND SHOWER ARM INSTALLATION:
Install a 1/2" threaded pipe nipple to extend beyond the finished
wall 3/8" to 1/2". Apply plumber's tape to thread on pipe nipple
and screw brass adapter (1) securely onto nipple. Screw
showerhead (2) onto the shower arm, using provided wrench (4)
to tighten securely. Check position of set screw on top of shower
arm (3) making sure it is not sticking through to the inside
opening where it could interfere with the assembly. Slide shower
1
arm and head assembly over the adapter and tighten set screw
against the adapter.
4
SHOWERHEAD AND SHOWER ARM INSTALLATION:
2
Apply plumber tape to threads on brass adapter (1). Install
adapter so that it extends beyond the finished wall 1-1/4" to
1-1/2". Ensure that O-Rings (2) are installed properly into
grooves on adapter.
Slide shower flange (3) over shower arm (4). Install shower arm
(4) onto brass adapter (1), and secure with set screw (5) on side
of shower arm. Slide flange (3) until it is flat against the finished
wall.
1 Vettis
Thread showerhead (6) onto shower arm. Do not overtighten
5
showerhead.
6
2
1
5
92781
3
4
2
®
only: Apply plumber tape to threads on shower arm (4).
1
RP75722p Shower Arm
RP48040p Shower Arm
RP62603p Shower Arm
RP90243p Shower Arm
RP92044p Shower Arm
1
pSpecify Finish
03/12/2018 Rev. A