Brizo Sotria RP75722 Serie Manuel D'installation

NOTE: It is suggested that you securely anchor water lines.
Sotria
RP75722p
3
4
2
SHOWERHEAD AND SHOWER ARM INSTALLATION:
Install a 1/2" threaded pipe nipple to extend beyond the finished wall 3/8" to 1/2". Apply plumber's tape to thread on pipe nipple and screw brass adapter (1) securely onto
nipple. Screw showerhead (2) onto the shower arm, using provided wrench (4) to tighten securely. Check position of set screw on top of shower arm (3) making sure it is not
sticking through to the inside opening where it could interfere with the assembly. Slide shower arm and head assembly over the adapter and tighten set screw against the
adapter.
Vettis
RP90243p
3
4
SHOWERHEAD AND SHOWER ARM INSTALLATION:
Apply plumber tape to threads on brass adapter (1). Install adapter so that it extends beyond the finished wall 1-1/4" to 1-1/2". Ensure that O-Rings (2) are installed properly
into grooves on adapter. Slide shower flange (3) over shower arm (4). Install shower arm (4) onto brass adapter (1), and secure with set screw (5) on side of shower arm. Slide
flange (3) until it is flat against the finished wall. Vettis
showerhead. For an additional 1-3/4" extension order RP101285.
2
STANDARD SHOWERHEAD AND SHOWER ARM INSTALLATION:
Connect top outlet (1) to shower arm (2) with proper fittings. To prevent damage to finish on shower arm, insert wall end of shower arm into shower flange (3) before screwing
arm into riser connection. Thread showerhead (4) onto shower arm. Apply plumber tape to pipe threads on both ends. Do not overtighten showerhead.
www.brizo.com
Virage
RP62603p
1
Levoir
RP92044p
2
1
5
6
® only: Apply plumber tape to threads on shower arm (4). Thread showerhead (6) onto shower arm. Do not overtighten
1
3
4
SHOWERHEAD AND SHOWER ARM INSTALLATION
103575
3
1
4
2
2
3
4
1
5
6
1
RSVP
RP48040p
3
4
2
RP101285p
Available Extension for Shower Arm
pSpecify Finish
1
11/07/2019 Rev. B