AR Blue Clean AR 390 SS Manuel D'assemblage, D'entretien Et D'utilisation page 7

ASSEMBLY INSTRUCTIONS
3
AA
Slip tab of stabilizer foot (E) into slot on bottom
righ, when facing the unit, of power washer unit (A).
Secure with screw (AA).
Hardware Used:
Screw
AA
5
B
To release the hose (B) from spray gun (H), turn black
collar counterclockwise. Remove gun.
A
E
H
4
High Pressure Hose Assembly
Connect the other end of high pressure hose (B) to
spray gun (H) by screwing collar over gun inlet. Hand
tighten (turning clockwise) until tight. Hose is now
securely attached to the spray gun.
Note: High pressure hose (B) is fitted to the hose reel
x 1
and ready to use. It only needs to be attached to the
spray gun (H).
H
B
7