Care And Maintenance - Craftsman CMXELAYMPL1030 Guide D'utilisation

occur. Before performing any maintenance, disconnect
power source from the work light.

WARNING: Burn hazard. Glass becomes hot during
use. Do not touch glass surface when work light is on
or immediately after use.
KNOW YOUR WORK LIGHT
READ THIS USER MANUAL AND SAFETY WARNINGS BEFORE
OPERATING YOUR UNIT. Compare the illustrations with your
unit to familiarize yourself with the location of switch and
adjustments. Save this manual for future reference.
SWITCH (FIG. A,E)
Press the swith 12 towards"I" to run at 100% light output.
Press the swith 12 towards"II" to run at 50% light output.
Press the swith 12 towards"O" to turn off the light.
Fig E.
Battery (Fig. A, F)
Plug in power cord 9 with switch
battery in 6 hours. Indicator Light
the work light is charging, and will be off after the work light
is fully charged. Unplug power cord
up to 4 hours with switch 12
in position "II".
Fig F.

WARNING: Fire hazard. Battery liquid may ignite
if exposed to spark or flame.
12
9
12 off to fully charge
14 will become red when
and light will run for
9
in position in "I" up to 8 hours
12
14
9

WARNING: Burn hazard. Never attempt to open
the battery pack for any reason.
Use only the included power cord to recharge this product.
NOTICE: Li-Ion batteries must be properly disposed of once
the battery is no longer functional. Please contact your
local recycling location for disposal. Wash your hands after
handling.

CARE AND MAINTENANCE


WARNING: To reduce the risk of serious personal
injury, turn unit off, disconnect it from power
source and put it on a stable secure position
before making any adjustments or removing/
installing attachments or accessories.

WARNING: When performing maintenance, you may
be exposed to voltage sources. Personal injuries can
occur. Before performing any maintenance, disconnect
work light from power source.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of the
work light. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid get
inside the work light; never immerse any part of the
work light into a liquid.
Repairs
This work light is not serviceable. There are no serviceable
parts inside the work light.
Accessories

WARNING: Since accessories, other than those
offered by CRAFTSMAN, have not been tested with
this product, use of such accessories with this product
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
used with this product.

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
Place work light on a stable surface where it will not
cause a tripping or falling hazard. Work lights may be
easily knocked over in certain situations.
Recommended accessories for use with your work light are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN, call 1-888-331-4569
Tripod (Sold Separately) (Fig. G)
This work light is compatible with Craftsman
CMXELAYMPL1031 tripod (Sold Separately), For details,
English
5