Care And Maintenance - Craftsman CMXELAYMPL1031 Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
to date compatible CRAFTSMAN work light model
numbers.
WORK LIGHT SOLD SEPARATELY
Insert the Lock Pin
 9 
from the bottom through the
mounting hole on the work light tripod bracket. Secure with
nut
10
.
Fig. E
Align the Lock Pin
on the work light with mounting hole
 9 
on the Tripod Head
 8 
, squeeze the Quick Release Clip
and insert the Lock Pin into the Tripod Head. Release the
Quick Release Clip
to secure the work light onto the
 7 
tripod.
Fig. F
9
Two Work Lights (Fig. G, H)

ALWAYS USE TWO IDENTICAL COMPATIBLE
CRAFTSMAN WORK LIGHTS AT THE SAME TIME
WHEN USING THE TWIN-LIGHT BRACKET. Using one
work light or two different work lights with the twin-
light bracket could cause the tripod to tip over.
Set Up the Twin-Light Assembly by placing the Twin-Light
Bracket
on a flat and stable surface. Secure the Central
 6 
Handle
 5 
with two Screws
(not included).
4
10
9
8
7
11
using a Philips screwdriver
Fig. G
11
Secure the work lights to the Twin-Light Bracket
Bracket Screws
12
Central Handle
 5 
on the tripod head
insert the twin-light assembly into the tripod head.
Fig. H
 7 
,
12
8

CARE AND MAINTENANCE


WARNING: TIPPING HAZARD. To reduce the risk of
serious injury, turn work light(s) off, disconnect
from power source, remove the work light or
twin-light assembly and put tripod on a stable
secure surface before making any adjustments or
performing maintenance to it.

WARNING: When performing maintenance, you may
be exposed to voltage sources. Personal injuries can
occur. Before performing any maintenance, disconnect
work light from power source and remove the work
light from tripod.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tripod. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid get
inside the tripod; never immerse any part of the tripod
into a liquid.
5
6
. Once both lights are secured, hold the
to align the lock pin to the mounting hole
, squeeze the Quick Release Clip
 8 
5
7
11
 5 
with
and
 7 
12

Publicité

Table des Matières
loading

Table des Matières