PEUGEOT ENERGYSAW 254DB Manuel D'utilisation page 39

1. CHANGING THE BLADE
Immediately replace the blade if you notice any signs of damage or other abnormalities.
The dulling and wear of saw blades can cause serious personal injury and make the saw's job of cutting ineffective.
CAUTION!
Y
- Before changing the blade, disconnect the power cord from the power socket. The power cord must always be un
plugged whenever you adjust or repair your saw.
- To avoid being injured by flying debris, do not use a blade diameter that's greater than or less than 255 mm.
- Do not use a dull blade. This could be dangerous.
Only use blades made for cross cutting. When using carbide tipped blades, make sure they have a zero or negative cut
ting angle. Do not use deep serrated blades since they can flex and make contact with the blade guard.
- Never use a blade thickness greater than that of the original blade.
1. Raise the saw head to the uppermost position.
2. Unscrew and remove the screw (A) Fig.22 that secures the plastic blade guard housing to the upper blade guard.
3. Remove the connecting part(B) Fig.22.
4. Unscrew and remove the pan head screws (C), which attach the plate of the blade guard and the lower blade guard to the
upper blade guard.
5. Turn the lower blade guard and the blade guard plate to the back in order to gain access to the screw shaft, see Fig.23.
6. Press the button to lock the shaft (A) Fig.24 then turn the blade by hand until the shaft is locked.
7. Remove the screw shaft (B) Fig.25 using the blade change key (A) that is provided. Turn the blade change key (A) clock-
wise to remove the screw shaft.
8. Remove the outer flange(C),then the blade.
9. Do not remove the inner flange except for cleaning. Make sure the interior surfaces of the interior and exterior flanges are
clean and free of foreign substances.
All manuals and user guides at all-guides.com
CARE AND MAINTENANCE
22
24
39
23
25