PEUGEOT ENERGYSAW 254DB Manuel D'utilisation page 28

The use of measures or procedures other than those specified here may cause hazardous radiation exposure.
• Never look in the direction of the laser beam.
• Do not aim the laser at people or animals.
• Do not use the laser on highly reflective materials. Reflected light is equally dangerous.
Motor:
Speed:
Blade size:
Crosscut at 90°:
Mitre cut at 45° L and R:
Bevel cut at 45° L and R:
Compound cut 45° R and 45° R:
Compound cut 45° L and 45° L:
Mitre stops R and L:
Bevel stop:
Laser:
Net weight:
Gross weight:
Your new mitre saw with dual bevel is shipped complete in a carton. Unpack it and all spare parts carefully as well and check
that it has not been damaged in transit. All unpainted parts are protected by an anti-rust film. Remove the protective coating
of all parts that are not painted before using the tool for the first time.
Note: If parts are damaged or missing, do not connect the mitre saw and do not turn the switch to "on" until the damaged or
missing parts have been obtained and properly installed.
Do not discard the carton in which the machine came before it is completely mounted.
1. Place the mitre saw on a level surface.
2. The saw comes with its head locked in the lowest position. To release it, push the saw head down, pull and turn the release
pin (A) Fig.17.
IMPORTANT: Do not lift the tool with the starting handle, always lock the head in the transport position and lift the saw by
the base or the carrying handle if there is one.
Y
CAUTION:
Do not use gasoline or other petroleum-based solvent for cleaning the machine after unpacking; these products are ex-
tremely flammable. A risk of explosion or fire exists if these products are used. In general, all solvents used for cleaning
machines are toxic when inhaled or ingested. Always work in a well ventilated area away from potential sources of solvents.
Wear a mask.
All manuals and user guides at all-guides.com
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER DEVICE
SPECIFICATIONS
2000W - 230 V AC 50Hz
5500 min¯¹
255 x 30 x 3.2 mm (40 teeth)
82 x 340 mm
82 x 240 mm
50 x 340 mm
25 x 240 mm
25 x 240 mm
0°- 15° - 22.5° - 30° - 45° R & L
0° and 45°
Class 2
20 kg
25 kg
UNPACKING AND CLEANING
28