Panasonic EY7441 Instructions D'utilisation page 12

IV. OPERATION
EN
WARNING!
• Do not inhale smoke emitted from the
main unit or battery pack as it may be
harmful.
[Main Unit]
CAUTION
When storing or carrying the tool, set the
Forward/Reverse lever to the center
position (switch lock).
NOTE:
Exercise caution to ensure no objects
come into contact with the tool's
trigger switch.
If an object comes into contact with
the tool's trigger switch, even while
the Forward/Reverse lever is in the
center position (locked), a small
amount of electric current may
excessive discharge from the battery
pack and subsequent battery pack
failure.
Switch and Forward/Reverse Lever
Operation [Fig.5]
1. Push the lever for forward or reverse
rotation. Check the direction of the
lever before using.
2. Depress the trigger switch slightly to
start the tool slowly.
3. Speed will increase by pressing the
trigger. The tool stops working
immediately by releasing the trigger.
4. When done with an application, lock the
switch by centering the lever.
NOTE:
When the brake operates, a braking
sound may be heard. This is normal.
CAUTION:
When operating the tool by pulling the
trigger, there may be a momentary lag
before rotation starts. This does not
signal a malfunction.
EY971074418.indb 12
* This lag occurs as the tool's circuitry
starts up when the trigger is pulled for
pack or after the tool has not been
used for at least 1 minute (or at least
5 minutes when the LED is on).
Rotation will start without any lag
during second and subsequent
operations.
CAUTION:
To prevent damage, do not operate
Forward/Reverse lever until the bit
comes to a complete stop.
Clutch Torque Setting
Adjust the torque to one of the 18 clutch
settings or " ", "
position.
CAUTION:
• Set the clutch setting at this mark
[Fig.6] before actual operation.
• If the clutch handle cannot be set at
"drilling" mode after driving with clutch
function, set the clutch handle at
position 1 and operate the clutch for a
second.
Speed Selection
Choose a low or high speed to suit the
use. (EY7441, EY7940, EY74A1,
EY7451) [Fig.7]
Choose a low, high or auto speed to
suite the use (EY7443) [Fig.8]
The more the variable speed control
trigger is pulled, the higher the speed
becomes.
The EY7443 offers AUTO mode, which
detects the load on the tool and
automatically switches between HIGH
and LOW speed operation.
When the load is low, the tool always
starts operation in HIGH speed.
When the tightening torque increases,
the tool switches to LOW speed. Keep
a secure grip on the tool so that it
doesn't twist out of your hands due to
the increased torque.
When operating in AUTO mode,
whether and when the tool switches
between HIGH and LOW speed
work conditions. These variations in
tool behavior are normal and do not
represent a malfunction.
- 12 -
(EY7940 only)"
2018-05-28 10:27:01