I/O Parameters; Network (Option) - Valentin DPM III XI Guide De Référence Rapide

DPM III xi
Key:

I/O Parameters

Keys: , , ,
Key:
Key:
Key:
Key:
Key:
Key:
Key:

Network (Option)

Keys: , , ,
For more information, please see the separate manual.
90
Standard layout:
On: If a print order is started without previous definition of layout, the standard layout (device
type, firmware version, build version) is printed.
Off: If a print order is started without previous definition of layout, an error message appears in
the display.
, ,
IN signal level:
Indication of signal at which a print order is started.
+ = active signal level is 'high) (1)
− = active signal level is 'low' (0)
x = not activated signal level
s = status can be affected by interface (in combination with Netstar PLUS)
OUT signal level:
Indication of signal level for output signal.
+ = active signal level is 'high) (1)
− = active signal level is 'low' (0)
s = status can be affected by interface (in combination with Netstar PLUS)
Debouncing:
Indication of debounce time of the dispenser input.
Value range: 0 ... 100 ms.
Start signal delay:
Indication in time per second of the delay for the start signal.
Value range: 0.00 ... 9.99.
IO protocol:
Indication of interface at which the modifications of input signals and output signals (I/O) are
sent.
Save signal:
On: The start signal for the next layout can already be released during printing the current
layout. The signal is registered from the printer. The printer starts printing the next layout
immediately after finishing the current one. Therefore time can be saved and performance be
increased.
Off: The start signal for the next layout can only be released if the current layout is printed to
the end and the printer is again in 'waiting' state (output 'ready' set). If the start signal was
released already before, so this is ignored.
Ready while printing:
Indication if the output signal 'print ready' (Out 5, Output II) remains active while printing.
Off: At print start the 'print ready' signal is inactive (default setting).
On: At print start the 'print ready' signal remains active.
, , ,
English